EN IT FR NL DigiDish 45 Satman 33 Satman 45 Multytenne 45 PL DigiDish 33 CZ Installation Manual Wall Mounting
EN NL Items supplied (see illustrations 1 and 2) PL CZ IT FR Dear customer, thank you for purchasing one of the quality products produced by TechniSat. In order to ensure that the quality of the product remains constant over many years, both the dish and the mounting bracket are made of aluminium. Please read the installation instructions carefully befor4e proceeding with the installation, to ensure that you can enjoy optimum reception performance after installation.
Mounting the external unit EN 1 NL Installation 22° 24° 26° 28° 29° 30° 31° 32° 33° 34° 35° 36° 37° 38° 40,40 44,52 48,77 53,17 55,40 57,74 60,00 62,49 64,90 67,45 70,02 72,65 75,36 78,13 3 Multytenne PL Gradient B (cm per m) CZ Selecting a location a) First ensure there is an uninterrupted line of sight from the intended mounting position in a southerly direction in order to receive signals from the satellite position ASTRA 19,2° East.
EN Safety notes When installing the unit, please conform with the various European standards and VDE regulations relating to the safety of electrical appliances and installations (e.g. VDE 0855, Part1). When in doubt, consult your retailer. FR IT 3 PL CZ NL 4.
IT 31,29° - 30° = 1,29° CZ Illustration 4 NL Loosen the screws (D) on the swivel profile so that you can move the external unit up or down. Place a rod or plank over the dish as shown in Illustration 4. Now use a protractor to set the angle calculated. FR 4. EN The offset angle of the DigiDish 33 resp. the DigiDish 45 is 30°. Therefore, if you are in Daun and using a DigiDish 33 resp. 45, this results in an angle of: PL Board/rod 5. 6. 7. 8. Now loosen the screw (C) resp.
EN IT FR NL CZ PL In order to receive the programmes of all 4 satellite positions via your digital receiver, you must programme these satellite positions in the antenna settings of your receiver, as per the operating manual of your receiver. Position/Option A/A B/A A/B B/B Switching criterion 1 2 3 4 Satellite Astra 19,2° East Eutelsat 13,0° East Astra 23,5 ° East Eurobird-Astra 28,5° East Set the 4 switching criteria of the DiSEqC control as follows: 1.
EN Sealing the LNB connection IT Dear customer, in order to prevent any moisture from entering the Multytenne LNB, please use the self-sealing duct tape supplied to insulate and seal the LNB connection. FR First remove the foil from the sealing tape. 2. Apply one end of the sealing tape approx. 1-2 cm below the F-connector. 3. Now stretch the sealing tape as much as possible, and wrap it around the co-axial cable and the F-connector, with overlapping edges.
EN IT FR NL CZ PL Your TechniSat Team Optional accessories: Tube clamp for mounting on a mast: Art. No.: 0000/0500 Balcony stand Art.No.: 0000/1751 This product bears the CE symbol, and complies with all relevant EU standards. Subject to change without prior notice, not responsible for printing errors. Correct as at 10/04 DigiDish and TechniSat are registered trademarks of TechniSat Digital GmbH Postfach 560 – D-54541 Daun/Germany www.technisat.
