Operation Manual

> Now turn the selection knob to mark the appropriate menu point and then select this

by pressing the selection knob.

6.1 Clock/Date

Under this menu point you can select whether the appliance’s clock/date shall be automati-

cally extracted from the dataflow of the station or whether you wish to set the hour and the

date manually.

The appliance is pre-set in such a way that the hour and the date can be automatically read

in. If you want to change the setting to manual then do as follows:

> Press the selection knob and then manually put in the setting by turning the

selection knob.

> Confirm this by pressing on the selection knob.

The following menu will appear.

> Now, by turning the selection knob mark the line for the setting of the hour and

then press the selection knob.

> Now, by turning the selection knob put in the correct hour and accept this by

pressing on the selection knob.

> Now by turning the selection knob mark the line for the setting of GMT-Offset and

then press the selection knob.

> Now, by turning the selection knob set the correct GMT-Offset and accept it by

pressing the selection knob.

> Now, by turning the selection knob set the line for the date and subsequently

press the selection knob.

> Now, by turning the selection knob put in the correct date and accept this by

pressing the selection knob.

> Now, by turning the selection knob mark the line Back and confirm this by

pressing the selection knob, in order to go back to Settings on the menu.

> Press once on the key marked Menu/Back.