Operation Manual

Transferring data into memory
> When you have completed the programming, press the yellow function key Accept
to transfer the data into memory.
If under Programme you have selected a programme that is blocked as per Point
8.3, you must first enter the PIN code before the data will be accepted into memory.
> Press the TV/Radio key to return to normal operation.
Timer overview
The timer overview function will display a list of all timer events already programmed.
> To display the menu Timer overview, call up the menu Timer organizing as
described above.
> Use the arrow keys up/down to mark the line Timer overview.
> Confirm by pressing OK.
If there is an overlap of timer events, these overlaps will be marked in red.
Changing timer programming
> To change an existing timer setting, use the arrow keys up/down to mark the
timer event you wish to change.
Press the yellow function key Change to move to the settings of the marked timer.
You can now effect the changes as described in Point 7.15.1.2.
> When you have completed the programming, press the yellow function key Accept
to transfer the data into memory.
Deleting timer programming
> To delete an existing timer setting, use the arrow keys up/down to mark the setting.
> Press the green function key Delete.
The message will be displayed:“Do you really want to delete this timer?”
> Use the arrow keys right/left to mark Yes.
> To delete the timer entry, confirm by pressing OK.
> Press the TV/Radio key to return to normal operation.
Programming a new timer event
> To programme a new timer event, use the arrow keys up/down to mark a free
line in the menu Timer overview.
> Press the yellow function key New to go to the entry window used to programme
the new timer event. Work through this as described above.
> Use the arrow keys up/down to mark the additional field Type.
> Confirm by pressing OK. A window will be displayed, showing the various available
types of timer.
> Use the arrow keys up/down to select the desired timer type.
> To accept the timer type, confirm by pressing OK.
> When you have completed the programming, press the yellow function key Accept
to transfer the data into the timer memory.
Note!!!
Please check that the unit has acquired the clock time. If activated as described in Point
6.2.5, this will be shown on the display in stand-by mode. If this is not the case, leave your
unit switched to a major channel for approx. 30 seconds, so that the current time can be
downloaded.
26