Operation Manual

7.14.7.2 Marking a programme
> Use the arrow keys or the function keys to mark/pre-select the desired .
> Confirm by pressing OK. The programme will be automatically marked, and will be
selected when the broadcast begins.
> Press Back to return to the previous table.
7.14.7.3 SFI Timer programming
Use the electronic programme guide SFI to simplify the programming of timer events.
Marking a programme
> Use the arrow keys or function keys to mark the appropriate programme
> Press OK to automatically mark the programme, the receiver will switch to this chan-
nel when the programme begins.
or
Recording a programme (timer operation)
> Use the arrow keys to mark the desired programme.
> Press the OK key twice to highlight the line in red and to accept the data for this pro-
gramme directly into the timer memory.
or
> Press the red function key (Timer/VCR) to open a selection window.
> Use the arrow keys up/down to mark your desired type of timer.
> Confirm by pressing OK.
The timer menu showing the data of the selected programme will be displayed for
monitoring purposes. If necessary, you can make alterations or corrections at this
stage (see 7.15).
> Press Back to return to the previous table.
The appropriate line will be highlighted. Your receiver will be switched on at the star-
ting time of the programme selected.Most of the functions of the remote control are
disabled at this stage to avoid any accidental interruption of the recording.
In standby mode the active timer will be indicated by the blinking of the colon in the
time display.
Delete timer operation
If you wish to delete a timer event programmed by means of the SFI, proceed as described
in Point 7.15. To abort an active timer, switch the digital receiver off by pressing the
On/Standby key.
Then press this key again to switch the receiver on, and proceed to operate it normally.
7.14.7.4 SFI Programme overview
The SFI programme overview function allows you to display the full daily programme of an
individual channel. Proceed as follows:
> Press the key SFI.
The SFI table “Now” will be displayed.
> Press the blue function key SFI Menu to open a selection window.
> Use the arrow keys up/down to mark the line Programmes.
> Confirm by pressing OK. The overview for today of the programme selected will be
displayed.
> Use the arrow keys to move the marker to the appropriate programme or starting time.
The individual days of the week are displayed along the lower border of your screen.
If information is available for the following days, the appropriate fields will be highlighted.
23