DigiDish 33 DigiDish 45 Satman Satman 45 Multytenne 45 For wall mounting Installation instructions 1
Dear customer, thank you for purchasing one of the quality products produced by TechniSat. In order to ensure that the quality of the product remains constant over many years, both the dish and the mounting bracket are made of aluminium. Please read the installation instructions carefully befor4e proceeding with the installation, to ensure that you can enjoy optimum reception performance after installation.
1 Mounting the external unit When you unpack the external unit, you will find that it has already been partly preassembled, so all you need to do is to mount the dish (item 2) and the connector piece (item 3). First, use the screws (A) to attach the dish to the AZ/EL bracket (item 1). Then loosen the screw (B) on the swivel profile in order to mount the connector piece. Then mount the LNB (item 5) on the LNB holder, using the LNB holding bracket (item 6) as shown in illustration 1.
3 Safety notes When installing the unit, please conform with the various European standards and VDE regulations relating to the safety of electrical appliances and installations (e.g. VDE 0855, Part1). When in doubt, consult your retailer. 4.
3. Consult an AZ/EL table to determine the elevation angle for your location. For Example, the angle fort he ASTRA 19,2° East satellite in the German town of Daun is 31,29°. As your external unit incorporates an offset dish, the angle of elevation to be set is not the angle in the table, but an adjusted angle which is calculated for the specific dish used. This is calculated as follows: Angle of Elevation – Offset angle = Angle to be set The offset angle of the DigiDish 33 resp. the DigiDish 45 is 30°.
Mounting advice Art. No. 0000/8810 Multytenne LNB Dear customer, Your Multytenne LNB ist designed for use with the SATMAN 45 satellite dish antenna. With this, you can receive the digital programmes of 4 orbital positions while located in Germany. Reception in neighbouring or other countries may be restricted.
Multytenne LNB Art.-Nr. 0000/8810 Sealing the LNB connection Dear customer, in order to prevent any moisture from entering the Multytenne LNB, please use the selfsealing duct tape supplied to insulate and seal the LNB connection. 1. First remove the foil from the sealing tape. 2. Apply one end of the sealing tape approx. 1-2 cm below the F-connector. 3. Now stretch the sealing tape as much as possible, and wrap it around the co-axial cable and the F-connector, with overlapping edges.
4. The LNB is now insulated and sealed, so that no water or humidity can penetrate. Your TechniSat Team Optional accessories: Tube clamp for mounting on a mast: Art. No.: 0000/0500 Balcony stand Art.No.: 0000/1751 This product bears the CE symbol, and complies with all relevant EU standards. Subject to change without prior notice, not responsible for printing errors. Correct as at 10/04 DigiDish and TechniSat are registered trademarks of TechniSat Digital GmbH Postfach 560 – D-54541 Daun/Germany www.
