Instructions

102
7.3.6 Retrieving blocked channels
If a channel is selected that is blocked by the parental control function, the
message Unit PIN will be displayed on the screen.
> Use the number keysto enter the unit PIN. The selected channel can now be
viewed.
or
> Change to an unblocked channel as described in Section 8.4 of your
instruction manual.
If global parental control is enabled, the unit PIN code will be requested
again when the blocked channel is switched on. To make things easier for
you, you only need enter the PIN code once during each operating phase.
When doing so, always pay careful aention to the information and seings
for global and user-dependent parental control (TechniFamily) in Section 16
of the instruction manual.
7.3.7 Back to the last channel selected
> Press the Back key on the remote control to return to the last channel
selected.
> Press the key again to return to the channel you were previously watching.
7.3.8 Switching between TV/Radio
> Use the TV/Radio key to switch between TV and radio mode.
The device switches to the last radio channel listened to.
Alternatively you can also switch between TV and radio mode as described
in Sections 8.4 and 11 of your instruction manual.
To do this also note the seing for OSD Radio/Music in Section 7.7.1.4 in your
instruction manual.
7.3.9 Selecting a regional channel
During the initial installation you selected your preferred regional programming. If
you now modify one of these channels, a note appears in the Infobox stating that
further regional programmes are available for selection.
> Use the Options selection to select between the various regional channels
under the item Region.
Digit S3 DVR_V2.indd 102Digit S3 DVR_V2.indd 102 23/02/2022 08:5323/02/2022 08:53