Manual

13.2.1 Seing the alarm time

The alarm function cannot be used until the correct time has been set. Depending on the set-up, this either occurs automatically

or needs to be set manually. The time can either be set manually or automatically using DAB USW or updated using the

Internet. See Section 14.3for further information.

> Select one of the alarm time memories (Alarm 1 or Alarm 2) and set the desired values point by point using the arrow

buons p /q (22, 24) and OK (9) on the remote control.

Repeat Choose between repeat options O (the alarm is switched o), Daily, Once,

Weekend (SAT-SUN), Working days (MON-FRI).

Time Set the time at which you wish to be woken.

If you have chosen Once as the repeat option, the date is also required.

Mode Select the source with which you wish to be woken. The following are available

Buzzer, Internet Radio, DAB, FM.

Programme Select whether playback should be from the source set beforehand, the Last listened to or one

of the Favourites memory seings.

Volume Select the volume with which you wish to be woken.

Save This saves the alarm seings.

The alarm seings are not accepted until selecting [Save].

The alarm is active provided you have set the alarm repeat to Daily, Once, Weekend, or Working days. The status bar

shows an alarm symbol with the corresponding number of the active alarm . In the O seing the alarm is not active

for the set time.

13.2.2 Switching o the alarm aer being woken

> Press the On/Standby (14) buon or Alarm (17) on the remote control to switch o the alarm.

The display shows [Alarm o] and the alarm symbol is shown again if the alarm repeat is set to Daily, Weekend or

Working days.