Stereo System User Manual

12
PROGRAMMING TRACKS FROM A CD
CD PROGRAMMING
When playing a CD, you can store a random sequence of up to
64 tracks to play in your preferred order.
Program entry takes place when the disc is stopped.
STORING A PROGRAM
To store a CD program:
Load the disc you want to play, wait for the disc to read.•
Touch the • MEMORY/CLOCK touchpad on the front panel
or press the CLOCK ADJ./PROGRAM button on the
remote control.
The Program Entry display will appear, prompting for the rst
track number to program (P-01).
Playing the program
When you have nished entering all tracks in your •
program, press the /,/SCAN button to start the
program playing.
Navigating the programmed tracks:
When the program is playing, the play and pause buttons
work as normal and you can skip between tracks in the
program by pressing the { or } button.
Clearing a program
If the CD is playing, press the • STOP/. button to stop the
disc.
Once the disc has stoppped, press the • STOP/. button
again.
The Program will clear from memory.
NOTE: Opening the disc loading door will also clear the
program.
Repeat function
When a program is stored you can set a repeat mode in •
the normal way if required.
Program
position
Track
number
Press the • { or } button to select the track number for
the rst track you want to program.
Touch the • MEMORY/CLOCK touchpad on the front
panel or press the CLOCK ADJ./PROGRAM button on
the remote control to store this track into the program
memory.
The track will be stored and the program counter will increase
to P-02.
Repeat the above two steps to store the next and •
subsequent tracks in your program sequence.