Stereo System User Manual

3
PREPARATION FOR USE
PROTECTIVE FILM
Some of the panels on this unit are protected by plastic lm
for protection in shipping. Remove all of this lm and any
tape securing it before use.
NOTE: Damage may result if lm or tape is left in place on the
sliding front panel and power is connected to the unit.
PLACEMENT
Placement on a table or shelf:
Place the unit on a sturdy table or shelf where it cannot get
knocked over and where there is a clear line of sight to the
remote handset.
Make sure that there is a clearance of 10cm (4 inches) above
the unit for ventilation.
Optional wall-mounting:
The MC-121IDAB system has back panel xings for optional
wall-mounting.
If you plan to wall-mount the system, you will need to x two
screws into the wall.
Before xing the screws, plan the location carefully, ensuring
that mains power is accessible.
Once you have planned the location, x two screws (not
supplied) into the wall to support the main unit, spaced by
240mm. Before mounting the screws, check the t of the
heads in the back panel keyhole slots to ensure that the
screw heads will not pull out of the slots.
240 mm
Use a spirit level to ensure that the screws will be level and
check that the unit will be xed at the height you require.
When you have mounted the screws, mount the unit
carefully onto the screw heads. Check that the mounting is
secure before use.
NOTE:- Most walls will require the use of wall-plugs when
mounting the xing screws. If you are in any doubt concerning
the type of xing required or the security of wall-mountings,
consult a building professional.
Important notes for wall-mounting:
Tesco accepts no liability for damages caused by incorrect •
assembly, installation or improper use.
Ensure that the wall has sucient strength to hold the •
weight of the system.
If there is any doubt regarding the condition or the load •
bearing of the wall, please consult a specialist from the
building trade.
The wall xings used must be suitable for the type of wall •
(materials, thickness, condition), so that the maximum
load bearing of the wall can be guaranteed.
Ensure that no electrical cables, water pipes or gas pipes •
are located within the wall.
Before mounting, check the location of the nearest •
mains socket.
Wear safety g• oggles when drilling.
Keep small parts out of reach from children.•