Operation Manual

44
Troubleshooting
Firmware update is available
• The firmware (free of charge) for this unit is
available.
Press [OK].
Press [ ], [ ] to select “Yes” and then press
[OK].
• The progress is displayed as “Updating
%” while updating. ( stands for a
number.)
• Do not disconnect the AC mains lead or
turn this unit to standby while updating.
( 38)
• When the update has finished successfully,
“Success” is displayed.
Disconnect the AC mains lead and reconnect
it after 3 minutes.
“F
” (“ ” stands for a number.)
• There is a problem with this unit.
- Is the volume extremely high?
If so, lower the volume.
- Is this unit placed in an extremely hot place?
If so, move this unit to a cooler place and
wait a few moments and then try to turn it
on again.
If the problem persists, write down the
displayed number, disconnect the AC mains
lead and consult your dealer.
Load Fail
• The firmware on the USB flash memory cannot
be found.
• Download the latest firmware on the USB flash
memory and try again. ( 38)
No Device
• No USB device is connected.
• Connect the USB device to be played. ( 26)
No Disc
• No CD is inserted.
• Insert the disc to be played ( 24).
No Network Available
• This unit is not connected to the network.
• Check the network connection. ( 18)
No Play
• The disc cannot be played back.
• Insert the disc to be played ( 45).
Not Measured
• Measuring the output signal has not been
done yet.
• Measure the output signal. ( 39)
Not Valid
• T
he function you have tried to use is not
available with the current settings. Check the
steps and settings.
PGM Full
• The number of programmed tracks is more
than 24.
Please Wait
• This is displayed, for example, when this unit
is turned to standby/on. (For up to approx.
1 minute and 30 seconds)
Reading
• The unit is checking the CD information. After
this display has disappeared, start operating.
“Remote
” (“ ” stands for a number.)
• The remote control and this unit are using
different codes.
Change the code on the remote control. ( 15)
Remote Mode
• Basic playback control buttons on the touch
panel/remote control are not available. (While
playing back music stored on the DLNA server
with this unit (DMR), etc.)
• Use the connected device for basic playback
control.
Searching
• The unit is checking the DLNA server on the
network.
Unlocked
• “PC” is selected, but a PC is not connected.
Check the connection with the PC. ( 31)
• Audio signals, such as sampling frequency
components, are not input correctly.
- About supported format, refer to “File
format” ( 50)
USB Over Current Error
• The iPhone/iPad/iPod or USB device is drawing
too much power. Disconnect the iPhone/iPad/
iPod or USB device and turn the unit to standby
and on again.
Wi-Fi Setup
• Select “On” and press [OK] to enter the
network setting. ( 19)
- To exit the network setting, select “Off” and
press [OK].
Hub Device Not Supported/Not Supported/
Device Not Recognized/USB Device Not
Supported
• You have connected an iPhone/iPad/iPod or
USB device that is not supported.
- If the iPhone/iPad/iPod is compatible, turn it
on and connect it correctly.
• The format of the file on the iPhone/iPad/iPod
or USB device is not supported.
- About supported format, refer to “File
format” ( 50)