Instruction Manual

26
Settings
System control connection
(26)
You can operate this unit and Technics devices supporting
system control function (Network Audio Player, Compact Disc
Player, etc.) simultaneously with ease on the remote control.
For details, refer to the operating instructions of each device.
System connection cable
Network Audio Player, etc.
Using system connection cable and
audio cable
1 Disconnect the AC mains lead.
2 Connect this unit and Technics device
supporting system control function
(Network Audio Player, etc.).
• Use both of the system connection cable and
the audio cables when connecting this unit
and the device.
• Use the system connection cable supplied
with the connected device.
3 Connect the AC mains lead to this unit.
( 13)
4
Press [AMP
] to turn this unit on.
5 Press [AMP].
6 Press [SETUP].
7 Press [
], [ ] repeatedly to select
“System Control” and then press [OK].
Coaxial digital cable
(not supplied)
*
8 Press [
], [ ] to select the input
source for the device which is
connected at step 2, and press [OK].
• Select “Off” to disable the system control
function.
*
: The illustration shows the example when
connecting with coax digital cable. Connect
the device with proper cable/terminal
supporting the device.
Note
• When using the system control function by
connecting the Technics device to the LINE2
terminal of this unit, select “LINE2” ( 17) for
the input setting of the analogue audio input
terminals (LINE2/MAIN IN) of this unit.
• When using this unit as power amplifier ( 18),
the system control function for the Technics
device connected to the MAIN IN terminals is
disabled.
• The system control function is not available
while “System Control” is set to “LINE2” and
“Input Mode” is set to “MAIN IN” ( 18) even
when not in use as main amplifier.