Operating Instructions

26
“Not Conditional”
The function you have tried to use is not available with the
current settings. Check the steps and settings.
“PGM Full”
The number of programed tracks is more than 24.
“Please Wait”
This is displayed, for example, when this unit is turned
on/off. (For up to 1 minute and 30 seconds)
“Remote ” (“ stands for a number.)
The remote control and this unit are using different codes.
Change the code on the remote control.
When “Remote 1” is displayed, press and hold [OK] and [1] for
at least 4 seconds.
When “Remote 2” is displayed, press and hold [OK] and [2] for
at least 4 seconds.
“Searching”
The unit is checking the DLNA server on the network.
“Unlocked”
“PC” is selected, but a PC is not connected. Check the
connection with the PC. (> 17)
Audio signals, such as sampling frequency components,
are not input correctly.
About supported format, refer to “File format” (> 29)
“USB Over Current Error”
The iPhone/iPad/iPod or USB device is drawing too much
power. Disconnect the iPhone/iPad/iPod or USB device
and turn the unit off and on again.
“Hub Device Not Supported”
“Unrecognizable Device”
“Unsupported”
“Unsupported USB Device”
You have connected an iPhone/iPad/iPod or USB device
that is not supported.
If the iPhone/iPad/iPod is compatible, turn it on and connect it
correctly.
The format of the file on the iPhone/iPad/iPod or USB
device is not supported.
About supported format, refer to “File format” (> 29)
Unit care
Pull out the AC power supply cord from the outlet before
maintenance. Clean this unit with a soft cloth.
When dirt is heavy, wring a wet cloth tightly to wipe the dirt, and
then wipe it with a soft cloth.
Do not use solvents including benzine, thinner, alcohol, kitchen
detergent, a chemical wiper, etc. This might cause the exterior
case to be deformed or the coating to come off.
ST-C700-SQT0495_PP_mst.book 26 ページ 2015年1月7日 水曜日 午前10時36分