Operating Instructions

25
Pairing cannot be completed.
Check the Bluetooth
®
device condition.
The device cannot be connected.
The pairing of the device was unsuccessful or the
registration has been replaced. Try re-pairing the device.
This unit might be connected to a different device.
Disconnect the other device and try re-pairing the device.
The device is connected, but audio cannot be
heard through this unit.
For some built-in Bluetooth
®
devices, you have to set the
audio output to “ST-C700” manually. Read the operating
instructions for the device for details.
NFC is not working.
Make sure the NFC feature of the device are turned on.
When you try again, change the angle at which the
Bluetooth
®
device touches the NFC touch area.
Turn on the NFC feature of this unit when you connect a
device using NFC. (> 18)
The remote control does not work properly.
To avoid interference, please do not put any objects in front
of signal sensor. (> 7)
Change the remote control code if other products react to
this remote control. (> 22)
If the SU-C700/SL-C700 is selected for the device to be
operated, press [NWP] and retry the operation. (> 8)
Pressing [DIMMER] changes the display, the light
and the indicator brightness of the SU-C700/SL-
C700.
[DIMMER] works for the SU-C700/SL-C700 as well as this
unit. Turn off the device that you want to maintain the
brightness level of, and press [DIMMER].
The following messages or service numbers may appear
on the unit’s display.
“AUTO OFF”
The unit has been left unused for about 20 minutes and will
enter standby mode within a minute. Press any button to
cancel it.
“Checking Connection”
The unit is checking the connected iPhone/iPad/iPod or a
USB device.
“Download Error”
The firmware download has failed. Press any button to exit.
Please try again later.
The server cannot be found. Press any button to exit. Make
sure that the network is connected to the Internet.
“Empty”
The selected folder is empty. Move tracks into the folder
and retry the operation.
The server is not found on the network. Check to see if the
server is connected to the same network as this unit, and
retry the connection to this unit. (> 13)
“Error
Incorrect operation is performed. Read the instructions and
try again.
“F” (“ ” stands for a number.)
There is a problem with this unit.
Is the volume extremely high?
If so, lower the volume.
Is this unit placed in an extremely hot place?
If so, move this unit to a cooler place and wait a few moments
and then try to turn it on again.
If the problem persists, write down the displayed number,
disconnect the AC power supply cord and consult your
dealer.
“No Network Connection”
This unit is not connected to the network.
Check the network connection. (> 12)
Bluetooth
®
Remote control
Messages
ST-C700-SQT0495_PP_mst.book 25 ページ 2015年1月7日 水曜日 午前10時36分