Operating Instructions

16
∫ Random repeat playback
Press [RND].
Each time you press the button:
∫ Repeat playback
Press [`].
Each time you press the button:

≥ You cannot use random repeat playback in combination with other
playback modes.
≥ You can use repeat playback in combination with program
playback.
This function allows you to program up to 24 tracks.
Preparation
≥It is not possible to program tracks by moving folders.
Move all the tracks you want to program to a single folder
in advance.
1 Press [PGM] in the stop mode.
≥“Program Mode” screen will be displayed.
2 Press [OK] to display the programming
screen.
3 Press [3, 4] to select the desired track.
4 Press [OK].
≥Do steps 3 through 4 again to program other tracks.
5 Press [1/;] to start playback.
≥To return to the “Program Mode” screen, press [∫].
Operations on the remote control

≥ Programed content is maintained as long as the input source is set
to “USB”.
≥ The program memory will be cleared:
– When the USB device is disconnected.
– When the unit is turned to standby or off mode.
≥ You can use program playback in combination with repeat
playback.
On
All tracks in a folder are repeated
randomly.
≥ “RND `” is displayed.
Off Turns off random repeat mode.
1-Track
Only plays the selected track.
≥ “1 `” is displayed.
All
All tracks in a folder are repeated.
≥ “`” is displayed.
Off Turns off repeat mode.
Program playback
Stop
Press [∫].
≥ Programed content is maintained.
Check the
programed
order
Press [2, 1] in the stop mode.
≥ To return to the “Program Mode” screen,
press [RETURN].
Add tracks Do steps 3 through 4 in the stop mode.
Clear the last
track
Press [CLEAR] in the stop mode.
≥ It is not possible to select and clear the
desired programed track.
Cancel
program mode
1 Press [PGM] in the stop mode.
≥ “Program Clear” is shown.
2 Press [3, 4] to select “Yes” and
then press [OK].
≥ The program memory will be cleared.
ST-C700-SQT0495_PP_mst.book 16 ページ ２０１５年１月７日 水曜日 午前１０時３６分