Operation Manual

16
When other equipment responds to the supplied remote
control, change the remote control code.
≥ The factory default is “Remote Mode 1”.
≥Only available from the SU-C700/ST-C700 remote control:
Point the remote control at this unit, and press
and hold [OK] and the numeric button for at least
4 seconds.
≥When the remote control code is changed, the new code
will appear on the display for a few seconds.

≥ When the SU-C700/ST-C700 is connected via the system control
function, change its remote control code as well as the remote
control code for this unit.
You can automatically link this unit with SU-C700 to operate
them.
Preparation
1 Connect this unit and the SU-C700 with a system
connection cable and a coaxial digital cable. (> 9)
2 Set the power switch lever of this unit and the SU-C700
to the [Í/I] position.
∫ Switching this unit and the SU-C700 to
on/standby simultaneously
≥When this unit and SU-C700 are in standby mode, while
pointing the SU-C700/ST-C700 remote control at this unit,
press [CD Í] so that this unit and SU-C700 switch on
automatically.
∫ Switching the SU-C700’s input source
automatically
When you perform an operation such as playback on this
unit, the input source of the SU-C700 will be automatically
switched to “COAX2”.

≥ For information on the operations of the SU-C700, please also
refer to its operating instructions.
Remote control code
[OK] + [1] Set the code to “Remote Mode 1”
[OK] + [2] Set the code to “Remote Mode 2”
Using the system control
function
SL-C700-SQT0708_E_mst.book 16 ページ ２０１５年６月１２日 金曜日 午後６時４９分