Owner's Manual
Table Of Contents
- Operating Instructions
- Read first
- Table of contents
- Features
- Accessories
- Control reference guide
- Connections
- Operations
- Settings
- Sound adjustment
- Adjusting the volume of headphones "PHONES VOL”
- Using this unit exclusively for the playback of CDs "Pure Disc Playback”
- MQA decoding "MQA Decoding”
- Enabling the native playback for DSD signal "DSD Native”
- Disabling audio output "Digital Output”/“Analog Output”
- Setting the sampling frequency "D.Output fs”
- Setting the analogue audio output "A.Output Level”
- Adjusting the sound quality of analogue audio output "Filter”
- Setting the limitation ofheadphones output "PHONES VOL Limitation”
- Playing back CD more natural-sounding audio
- Direct mode
- Other settings
- Using the favourite function
- System control connection
- Sound adjustment
- Others
89
(Continued)
Using system connection cable
and audio cable
1 Disconnect the AC mains lead.
2 Connect this unit and Technics device
supporting system control function
(Stereo Integrated Amplifier, etc.).
• Use both of the system connection cable and
the audio cables when connecting this unit and
the device.
• Use the system connection cable supplied with
the connected device.
3 Connect the AC mains lead to this unit.
(⇒ 27)
4 Press [NWP
] to turn this unit on.
5 Set the system control function on the
connected device.
• For details, refer to the operating instructions of
the connected device.
Switching this unit and the
connected device to on/standby
simultaneously
When the device supporting system control
function (Stereo Integrated Amplifier, etc.) is turned
on/off, this unit is turned on/off automatically.
1 Press [NWP].
2 Press [SETUP].
3 Press [
], [ ] repeatedly to select
“Power On Link”/“Power Off Link” and
then press [OK].
4 Press [
], [ ] to select “On” and then
press [OK].