User Manual

12
Connections
(12)
Basic
Connecting to an amplifier
XLR cable
*
(not supplied)
Analogue audio
cable (supplied)
Amplifier
(AV receiver, control amplifier, etc.)
Pre-amplifier with
unbalanced input
terminals
Pre-amplifier with
balanced input
terminals
*
: We recommend using cables with a length of
3 m or less.
 For details, refer to the operating instructions of
the connected device.
 Do not use any other analogue audio cables
except the supplied one.
Connecting to a digital audio output
device
Digital audio output device
Optical digital
audio cable
(not supplied)
Coaxial digital
cable
(not supplied)
 Audio signal of Super Audio CD and Super
Audio CD layer of Hybrid Super Audio CD
cannot be output from the digital audio output
terminal of this unit. Connect the device to the
analogue audio output terminal.
 When enjoying video contents with this
function, the video and audio output may not
be synchronised.
 For details, refer to the operating instructions of
the connected device.
AC mains lead connection
Connect only after all other connections are
completed.
To a household
mains socket
AC mains lead
(supplied)
Insert the AC mains lead up to a
point just before the round hole.
 Use only the supplied AC mains lead.
 Insert the plugs of the cables to be connected
all the way in.
 Do not bend cables at sharp angles.
 Wireless LAN (Wi-Fi
®
) setting may start when
this unit is turned on. If you stop the Wi-Fi
setting, select “No” in “Wi-Fi Setup” screen.
Select “Yes” to keep the Wi-Fi setting. ( 14)
 Press [NWP]/[CD] first to operate this unit.
Note
 This unit consumes a small amount of AC power
( 20) even when the unit is in standby mode.
Remove the plug from the main electrical outlet
if you will not be using the unit for an extended
period of time. Place the unit so the plug can be
easily removed.