Owner's Manual

32
(Continued)
4 Press [ ], [ ] to select “On” and then
press [OK]. (The wireless LAN function
is enabled.)
5 Press [
], [ ] to select “WPS Push” and
then press [OK].
• “WPS” blinks. Complete step 6 within
2 minutes.
6 After “WPS” is displayed, press the WPS
button on the wireless router.
Example:
• “Linking” blinks.
• When the connection is established, “Success”
is displayed.
 “Fail” may be displayed if the connection was
not complete. Try this method again from the
setup menu. If “Fail” is still displayed, try other
methods.
7 Press [OK] to exit the setting.
■
Using the WPS PIN code
“WPS PIN”
If your wireless router supports WPS, you can set up
a connection by entering the WPS PIN code.
• For details on how to enter the PIN code, refer to
the operating instructions of the wireless router.
• Complete the settings within 2 minutes while
“WPS PIN” and the PIN code are displayed.
• When “Wi-Fi Setup” is displayed when turning on
this unit, press [
] to cancel the network setting
and start the setting again.
1 Press [NWP].
2 Press [SETUP].
3 Press [
], [ ] repeatedly to select
“Network” and then press [OK].
• When “Wi-Fi” screen is displayed, press [OK].
4 Press [ ], [ ] to select “On” and then
press [OK]. (The wireless LAN function
is enabled.)