Operating Instructions

16
When other equipment responds to the supplied remote
control, change the remote control code.
≥ The factory default is “Mode 1”.
≥Only available from the SU-C700/ST-C700 remote control:
Point the remote control at this unit, and press
and hold [OK] and the numeric button for at least
4 seconds.
≥When the remote control code is changed, the new code
will appear on the display for a few seconds.

≥ When the SU-C700/ST-C700 is connected via the system control
function, change its remote control code as well as the remote
control code for this unit.
Select English or French for the display.
≥ The factory default is “English”.
≥Operation with the touch panel on the unit:
1 Touch [MENU] repeatedly to select “Setup”
and then touch [1/;].
2 Touch [MENU] repeatedly to select
“Language”.
3 Touch [:, 9] to select “English”/
“Français” and then touch [1/;].
4 Touch [∫] twice after you have finished
setting.
≥Operation with the SU-C700/ST-C700 remote control:
1 Press [CD].
2 Press [MENU].
3 Press [3, 4] repeatedly to select “Setup”
and then press [OK].
4 Press [3, 4] repeatedly to select
“Language”.
5 Press [2, 1] to select “English”/“Français”
and then press [OK].
6 Press [MENU] after you have finished
setting.
You can automatically link this unit with SU-C700 to operate
them.
Preparation
1 Connect this unit and the SU-C700 with a system
connection cable and a coaxial digital cable. (> 9)
2 Set the power switch lever of this unit and the SU-C700
to the [Í/I] position.
∫ Switching this unit and the SU-C700 to
on/standby simultaneously
≥When this unit and SU-C700 are in standby mode, while
pointing the SU-C700/ST-C700 remote control at this unit,
press [CD Í] so that this unit and SU-C700 switch on
automatically.
∫ Switching the SU-C700’s input source
automatically
When you perform an operation such as playback on this
unit, the input source of the SU-C700 will be automatically
switched to “COAX2”.

≥ For information on the operations of the SU-C700, please also
refer to its operating instructions.
Remote control code
[OK] + [1] Set the code to “Mode 1”
[OK] + [2] Set the code to “Mode 2”
Language
Using the system control
function
(16)
SL-C700-SQT0934.book 16 ページ ２０１５年３月２４日 火曜日 午後５時３３分