Owner's Manual
Table Of Contents
- Owner's Manual
- Service Manual
- Table of Contents
- Safety Precautions
- Warning
- Specifications
- Location of Controls and Components
- Troubleshooting Guide
- Disassembly and Assembly Instructions
- Types of Screws
- Disassembly Flow Chart
- Main Components and P.C.B. Locations
- Disassembly of T/T Rubber Matand Turntable Ass’y
- Disassembly of Insulator Unit
- Disassembly of Bottom Chassis Ass’y
- Disassembly of DC Motors
- Disassembly of Phono Out P.C.B.
- Disassembly of Tone Arm All Unit Ass’y, Queuing Knob and Armrest Ass’y
- Disassembly of Main P.C.B.
- Disassembly of SMPS P.C.B.
- Disassembly of Panel P.C.B.
- Measurements and Adjustments
- Block Diagram
- Wiring Connection Diagram
- Exploded View and Replacement Parts List
30
4. Set auto lift-up point according to the distance.
Distance : 51.5 mm to 56.5 mm ---- position 1
Distance : 57.0 mm to 60.5 mm ---- position 2
To confirm setting 1 or 2,
press Speed select button [33] briefly. [33]LED flashing shows which postion is setting for 3 seconds as follows.
Position 1 : 1 sec. period Duty 50% (500ms:ON, 500ms:OFF --- 3 times)
Position 2 : 2 flashing within 1 second (100ms:ON, 100ms:OFF, 100ms:ON, 700ms:OFF --- 3 times)
To set the posittion 1 or 2 according to the distance, press and hold the Speed select button [33] for 3 seconds or more.
5. Exist the Adjustment Mode and Service Mode.
Turn the power "OFF" with [POWER SW], or pull out the AC cord.