Owner's Manual
Table Of Contents
- Owner's Manual
- Service Manual
- Table of Contents
- Safety Precautions
- Warning
- Specifications
- Location of Controls and Components
- Troubleshooting Guide
- Disassembly and Assembly Instructions
- Types of Screws
- Disassembly Flow Chart
- Main Components and P.C.B. Locations
- Disassembly of T/T Rubber Matand Turntable Ass’y
- Disassembly of Insulator Unit
- Disassembly of Bottom Chassis Ass’y
- Disassembly of DC Motors
- Disassembly of Phono Out P.C.B.
- Disassembly of Tone Arm All Unit Ass’y, Queuing Knob and Armrest Ass’y
- Disassembly of Main P.C.B.
- Disassembly of SMPS P.C.B.
- Disassembly of Panel P.C.B.
- Measurements and Adjustments
- Block Diagram
- Wiring Connection Diagram
- Exploded View and Replacement Parts List
25
6.9.1. Removing the Queuing Knob
Step 1 Remove the Queuing Knob as arrow shown.
6.9.2. Removing the Armrest Ass’y
Step 1 Hold the Arm-height Adjuster to lift up to 6 mm.
Step 2 Remove screw.
Step 3 Remove Armrest Ass’y.
Note: When attaching and removing the Armrest Ass’y, use
a Driver Bit (No. 2) or small type of Monkey Wrench, etc. to
remove the screw because of the narrow gap (max 25 mm)
of the fixing screw part of the Armrest Ass’y. Do the same
when attaching.
Note: When using a commercially sold Board Ratchet
Driver, use a driver suitable for working in the gap of 25
mm.