Owner's Manual
Table Of Contents
- Owner's Manual
- Service Manual
- Table of Contents
- Safety Precautions
- Warning
- Specifications
- Location of Controls and Components
- Troubleshooting Guide
- Disassembly and Assembly Instructions
- Types of Screws
- Disassembly Flow Chart
- Main Components and P.C.B. Locations
- Disassembly of T/T Rubber Matand Turntable Ass’y
- Disassembly of Insulator Unit
- Disassembly of Bottom Chassis Ass’y
- Disassembly of DC Motors
- Disassembly of Phono Out P.C.B.
- Disassembly of Tone Arm All Unit Ass’y, Queuing Knob and Armrest Ass’y
- Disassembly of Main P.C.B.
- Disassembly of SMPS P.C.B.
- Disassembly of Panel P.C.B.
- Measurements and Adjustments
- Block Diagram
- Wiring Connection Diagram
- Exploded View and Replacement Parts List
23
6.7. Disassembly of DC Motors
• Refer to “Disassembly of T/T Rubber Mat and Turntable
Ass’y”.
• Refer to “Disassembly of Insulator Unit”.
• Refer to “Disassembly of Bottom Chassis Ass’y”.
Step 1 Remove 3 screws.
Step 2 Detach 11P Wire at connector (P3101) on Main P.C.B..
Step 3 Separate the Cabinet Ass’y from the Dust Cover Unit.
Step 4 Remove the DC Motors.
6.8. Disassembly of Phono Out
P. C. B .
• Refer to “Disassembly of T/T Rubber Mat and Turntable
Ass’y”.
• Refer to “Disassembly of Insulator Unit”.
• Refer to “Disassembly of Bottom Chassis Ass’y”.
Step 1 Remove 4 screws.
Step 2 Remove screw and Earth Wire.
Step 3 Remove Jack Holder.
Step 4 Detach 3P Wire at connector (P4001) on Phono Out
P. C .B . .
Step 5 Remove 3 screws.
Step 6 Remove RCA Shield.
Step 7 Remove 2 screws and Arm Wire Ground Plate.
Step 8 Unsolder 5P Wires on Phono Out P.C.B..
Step 9 Remove Phono Out P.C.B..
Caution: During assembling of 5P Wires, ensure wires
properly seated on top of arm wire cushion.