Owner's Manual
Table Of Contents
- Owner's Manual
- Service Manual
- Table of Contents
- Safety Precautions
- Warning
- Specifications
- Location of Controls and Components
- Troubleshooting Guide
- Disassembly and Assembly Instructions
- Types of Screws
- Disassembly Flow Chart
- Main Components and P.C.B. Locations
- Disassembly of T/T Rubber Matand Turntable Ass’y
- Disassembly of Insulator Unit
- Disassembly of Bottom Chassis Ass’y
- Disassembly of DC Motors
- Disassembly of Phono Out P.C.B.
- Disassembly of Tone Arm All Unit Ass’y, Queuing Knob and Armrest Ass’y
- Disassembly of Main P.C.B.
- Disassembly of SMPS P.C.B.
- Disassembly of Panel P.C.B.
- Measurements and Adjustments
- Block Diagram
- Wiring Connection Diagram
- Exploded View and Replacement Parts List
22
6.4. Disassembly of T/T Rubber Mat
and Turntable Ass’y
Step 1 Remove T/T Rubber Mat and Turntable Ass’y as arrow
shown.
Note:
• The Tone Arm Unit should be supported by Arm Rest.
• Take care not to stick the dust or iron powder to the
magnet attached to back inner side of turntable.
6.5. Disassembly of Insulator Unit
• Refer to “Disassembly of T/T Rubber Mat and Turntable
Ass’y”.
Step 1 Place the Dust Cover Unit on Cloth.
Step 2 Flip Cabinet Ass’y and put it on Cushion to prevent
scratch.
Step 3 Turn the 4 Insulator Unit in the direction of arrow and
remove them.
6.6. Disassembly of Bottom Chas-
sis Ass’y
• Refer to “Disassembly of T/T Rubber Mat and Turntable
Ass’y”.
• Refer to “Disassembly of Insulator Unit”.
Step 1 Remove 14 screws.
Step 2 Remove Bottom Chassis Ass’y as arrow shown.