User Manual
Table Of Contents
- Read Before Use
- Operating Instructions
- Adjusting the Turbtable Startup/Brake Speed
- Owner's Manual
- Label Stickers
Armlift height
Make
an
adjustment according
to
your
cartridge if necessary.
Preparation
• Put a record on the turntable.
• Remove the stylus cover, taking care
not
to
damage the stylus, then release the arm
clamp.
• Lift the cue lever and move the tone arm over
the record.
1 Check the armlift height (distance
between
the
stylus
tip and record
surface).
If adjustment
is
needed, go
to
step 2 .
• The armlift height
is
factory-adjusted
to
8
to
13
mm (
5
/15"
to
33
/54").
2 Return
the
tone
arm
to
the
arm
rest and fix it with
the
arm clamp.
Turn
the
adjustment screw.
• Turning the screw clockwise lowers the
arm lift.
• Turning the screw anti-clockwise
raises
the armlift.
Armlift
Armlift
screw
Adjusting
the
turntable startup/
brake speed
BRAKE
button
e,~\{E
S (Slow)
__
s~.t
F (Fast)
~
Confirmation lamp
@)
Torque
button
~
L (Low) L H
H (High) TORQUE
•
Press
the center
of
the button lightly.
Startup speed
You
can
select from three options
of
the startup
speed (the time
to
reach the constant speed) after
[START-STOP]
is
pressed and the torque gain at the
constant speed.
(Factory setting: 3)
[TII]
IFast
startup
l
[]ill !Slow startup
CDThe
confirmation lamp blinks the specified number
of
times according
to
the current setting when you
press the H or L torque button.
~To
change the setting,
press
the H or L torque
button while the lamp
is
lit.
Example:
lf
the current setting
is
[3] and you
press the L button twice, the setting will
change
to
[1
].
®After
you press the torque button, the
confirmation lamp blinks the specified number
of
times showing the new setting, stays lit
for
two
seconds and then goes off.
Brake speed
You
can
select from five options
of
the brake speed
to
stop the turntable after
[START-STOP]
is
pressed .
(Factory setting:
5)
[ill
!Stops fast
l
[]ill !Stops slowly
CDThe
confirmation lamp blinks the specified number
of
times according
to
the current setting when you
press the
For
S brake button.
~To
change the setting, press the F or S brake
button while the lamp
is
lit.
Example:lf the current setting
is
[5] and you
press the S
button
twice, the setting will
change
to
[3].
®After
you press the brake button, the confirmation
lamp blinks the specified number
of
times showing
the
new
setting, stays lit
for
two
seconds and then
goes off.
{21)
21
English