User Manual
Table Of Contents
- Read Before Use
- Operating Instructions
- Adjusting the Turbtable Startup/Brake Speed
- Owner's Manual
- Label Stickers
Installation
Install
the
unit on a horizontal surface
protected from vibrations.
Keep this unit
as
far
as
possible from speakers.
■
Adjusting the height
to
make the
unit horizontal
Increases
the height
Raise
the main unit
to
turn the insulators and
adjust the height.
• Clockwise: Reduces the height.
• Anti-clockwise: Increases the height.
Attention
•
Do
not
turn the insulators
too
far.
Doing
so
may cause them
to
come
off
or
damage them.
Fit
the
dust cover
1 Hold the dust cover with both
hands and insert it into the dust
cover fitting parts ( ¢ 11) on the
player.
•
To
remove the dust cover, keep it open
and lift it straight above.
I
f4H4•0i•i••
• Return the tone arm
to
the arm rest and fix
it with the arm clamp before
you
attach or
detach the dust cover.
• When inserting the dust cover, prevent the tip
of
the hinges from hitting and damaging the
main unit.
■
Notes for installation
• Before you move the unit, remove
all
devices
connected and turn
off
the power supply.
•
Ensure
the unit
is
not exposed
to
direct
sunlight, dust, humidity, and heat from a
heating appliance.
•
This
unit may pick up interference from a
radio if there
is
one nearby.
Keep the unit
as
far
as
possible from a radio.
•
Do
not
install the unit on a heat source.
• Avoid a
place
with large temperature variations.
• Avoid a place
with
frequent condensation.
• Avoid
an
unstable place.
•
Do
not
put
an
object on the unit.
•
Do
not
install the unit
in
a confined
space
such
as
a book shelf.
• Install the unit at a position well away from
walls or other devi
ces
to
ensure effective
heat radiation from the inside
of
the unit.
• Make sure
that
the material
of
the
installation location
is
sufficiently strong
to
withstand the
weight
of
this unit.
• Note
that
the unit may
be
damaged
by
cigarette smoke or moisture from
an
ultrasonic humidifier.
■
Condensation
Think
of
taking
out
a cold bottle from a
refrigerator. If you leave it
in
a room for a while,
dewdrops will form on the bottle surface.
This
phenomenon
is
called "condensation".
• Conditions causing condensation
◊
Rapid
temperature change (caused
by
moving from a warm place
to
a cold place or
vice versa, rapid cooling or heating, or direct
exposure
to
cooled air)
◊
High humidity
in
a room
with
much steam,
etc.
◊
Rainy season
• Condensation may damage the unit. If it
has
occurred, turn the unit
off
and leave it
until it adapts
to
the ambient temperature
(approximately 2
to
3 hours).
(17) 17
English