Operation Manual

27
Using iPhone/iPad/iPod
Operations
1 Connect an iPhone/iPad/iPod to the
unit.
2 Press [USB].
• The display will automatically change to
“iPod_Port” when a compatible iPhone/
iPad/iPod is connected to the USB-A
terminal.
3 Start playback on the iPhone/iPad/
iPod.
Operations during playback
Stop
Pause
• Press again to restart play.
Skip
Search
• On the unit: touch and hold
[ ] or [ ].
• For “Repeat” and “Shuffle”. ( 35)
Note
• Compatibility depends on the software version.
Update your iPhone/iPad/iPod to the latest
software before using it with this unit.
• Operation results may vary depending on the
iPhone/iPad/iPod models or the iOS version.
Charging an iPhone/iPad/iPod
During unit on, charging starts when an iPhone/
iPad/iPod is connected to this unit.
• To continue charging from the USB cable
connection during standby mode, make sure
the iPhone/iPad/iPod has started charging
before turning the unit to standby mode.
• Check the iPhone/iPad/iPod to see if the
battery is fully charged. Once fully charged,
remove the iPhone/iPad/iPod.
Note
• When this unit is in standby mode, “iPod
Charging” is displayed and the power indicator
lights red.
• Charging stops when the battery is fully
charged. The battery will deplete naturally.
• When charging an iPhone/iPad/iPod whose
battery is depleted, do not turn this unit to
standby mode until the iPhone/iPad/iPod
becomes operational.
Connect an iPhone/iPad/iPod to the unit using
USB cable
*
, and you can play back music stored on
iPhone/iPad/iPod or charge iPhone/iPad/iPod.
• Refer to “iPhone/iPad/iPod” ( 45) for
information about the iOS device this unit can
play back.
*
: Use the USB cable supplied with iPhone/iPad/
iPod.
USB cable
(supplied with iPhone/iPad/iPod)
iPhone/iPad/iPod