Operation Manual

19
Connections
Wireless LAN connection
■
Preparation
Disconnect the AC mains lead.
Disconnect the LAN cable. (When a LAN
cable is connected, the Wi-Fi function may be
disabled.)
Place this unit as close to the wireless router
as possible.
Point up the antenna on the rear of this unit
as shown in the figure.
Connect the AC mains lead to this unit ( 17)
Note
• Do not perform the following:
- Applying too much force to the antenna
- Carrying this unit by holding the antenna
• The setting will be cancelled after the set time
limit. In that case, try the setting again.
• To cancel this setting in the middle, press [
]
or turn the unit to standby mode.
■
For the first time
1 Press [ ] to turn this unit on.
• “Wi-Fi Setup” is displayed.
2 Press [ ], [ ] to select “On” and then
press [OK].
• “WAC Mode for iOS” automatically starts.
3
(For “WAC Mode for iOS”)
Proceed to step 2 ( 20).
(For other network setting method)
Choose a network setting methods.
Note
• When this unit is switched to standby mode
and turned on before the Wi-Fi setting is
complete, “Wi-Fi Setup” is displayed. Perform
the Wi-Fi setting or select “Off”.
■
Choose a network setting method
Are you using an iPod touch/iPhone/iPad?
Yes
(iOS version 7.0 or later)
Using the WAC (Wireless Accessory
Configuration) ( 20)
(iOS version 5.0 or later)
Using iPhone/iPad/iPod ( 20)
No
Does your wireless network router support
WPS (Wi-Fi Protected Setup™)?
Yes
(WPS button)
Using the WPS button ( 21)
(WPS PIN code)
Using the WPS PIN code ( 21)
No
Are you using an Android device?
Yes
Using “Technics Music App” ( 22)
No
Using an internet browser ( 22)
■
Settings using [SETUP] menu
1 Press [SETUP].
2 Press [
], [ ] repeatedly to select
“Network” and then press [OK].
• When “Wi-Fi” screen is displayed, press
[OK].
3 Choose a network setting methods.