Dear customer Thank you for purchasing this product. For optimum performance and safely, please read these Instructions carefully. Table of contents 4 4 Precautions Supplied access Ones v Concerning the remote control .. To enjoy surround sound . Front pane controls Connections Connecting audio equipment _ Connecting video equipment .. Conn acting a DVD plays Antenna connections Connecting the AC power supply cord and other information .
Precautions Before using this unit please read these operating instructions carefully, Take special care to follow the warnings indicated on the unt itself as well as the sally suggestions listed below, Afterwards keep them handy for future reference. N Selfishly ] . Power Source—The unit should be connected to power supply only of the type described in the operating instructions or as marked on the unit.
RQTS212 Transmission window About 7 meters (23 feel} in front of the signal sensor. {The actual range will depend on the angle at which the remote control is used.) i “ Supplied accessories Please check and identify the supplied accessories, [ @ AC power supply cord (RJAD0E5-4) [0 ® AM too antenna set (RSAD012) « AM loop antenna # AM loop antenna holder ® [0 @ FM indoor antenna {RSAQD0S) [ @ Bakeries . [ ® Re mole control {EXURBAN} Use numbers indicated in parentheses when asking for replacement parts.
{ To enjoy surround sound l or with Dolby Digital or DTS played on a DVD player connected to this unit's DVD 6CH INPUT terminals. Do the connections, settings, and adjustments in the order shown 10 enjoy surround sound with this unit's Dolby Pro Logic or SFC features, ' B 1 Connect the equipment (= Page 8-11.) Lot Position and connect the speakers (% Page 12-13)) When using Dolby Pro Logic and When using DVD 6CH INPUT SFC (= Page 24.) (= Page 20-23.
AGT5212 Front panel controls Main unit J No. Name Ref.page No. Name Ref.page @© Power “ O /i switch (POWER, Center mode select bunion Press to switch the unit from on to standby mode or vice versa. In standby mode, the unit is still consuming a small amount of power. (2 Sound mode selector/indicators. @ SFC mode selector (SFC MODE)..
l Front panel controls l [ Remote control W No. Name Reportage © Power button () & » button button & button & Top menu button (TOP MENU) @ Display button @ Dolby Pro Logic SURROUND select button (SURROUND @ Dolby Pro Logic .
Connections Stereo connection cable (not included) White (L) Red (R) Video connection cabin {not included) [l Make sure that the power supply for all components has been To connect equipment, refer to the appropriate operating turned off before making any connections. instructions. L Connectinglaudiclequipment [ CD player {or CD changer) {not included) Tape deck (not included) Turntable (rot included) OUTPUT 1 GND Only for am e worse L) o = OUTPUT AEC (1IN} PLAY (OUT) B8 R turntable with ground terminal.
Monaural connection cable (not included} Optical fiber cabin (not included) <3 = [ come sings ey ] @ Direct connection of the DVD player DVD player with 6ch output DVD player with 2ch output AUDIO OUT {not included) {not included) (SURROUND L,R) VIDEO § a0 2 AUDIO OUTRE (SUB WOOFER) AUDIO QUT AUDIO OUT (FRONT LR} r {CENTER) o VIDEO our @ Connection through a digital surround processor Digital surround processor {not included) AUDIT QUT AUDIO OUT {(FRONT IR} {SUB WOOFER) f I i our 2 ()10 (CENTER) AUDIO OUT A
‘ Connections loop antenna Fit the AM loop antenna holder (included) onto the rear pane! of this unit and then ‘ attach the AM loop antenna to the AM loop antenna held (facing in the direction of best reception). Keep loose antenna cord away tram other wire cords or a tape deck. i When mounting the antenna i to a column, a wall or rack FM antenna Fix the other end of the antenna where reception is best. indoor antenna i fl .
[ Enmeshing Te AC power sl ire) ane lore Fermenting Cooling fan The cooling fan operates at high power output levels only. “SWITCHED"” AC outlet Power to the outlet is controlled by the power switch of this unit. Audio equipment rated up to MAX 80 W can be connected here. T AC OUTLET AC power supply cord (Included) (AC 120 VA0 Hz) — ) TREE/ . Connect this cord ¢ . only after all other observing power cables and cords are The unit consumes 1 W of power even when it is turned off with connected.
Speaker connections [ Selfless of speller Front speaker (not. Included) (left {not included) . Surround speak ety {not included) Center speaker Front speaker {right) {pot included) Sub woofer {not included} Surround speaker (right) (not included) The front, center, and surround speakers should be placed at approximately the same distance from the listening position.
Center speaker Conner speaker (not included) & Speaker cable (ot included) ey e ey SURROUND ;CENTER FRONT LY Speaker impedance: 8Q Surround speakers [ Surround speaker, Surround speaker e {right) (sift) m £ {not included) {not included) CoL Speaker cables, D L., 22 {not included) swallow e FRO Subaltern Active submitter NUT {not included) @ Monaural connection cable {not included) s This receiver has no amplifier section designed especially for the sub woofer.
TROTSKY VOLUME 3 INPUT SELECTOR Selected source | Basic operations | Be tore operation, set [VOLUME] ta the “MIN” position Press [POWER, 2 Press [A] and/or [B] to select the speaker system(s) to be used. A and B refer to the speaker terminals at the rear of the unit. 1f the button is pressed once more, the indicator will switch off and no sound will e heard from the speakers. 3 Tun [INPUT SELECTOR] to select and start the desired source. {Refer to the appropriate aerating instructions far details.
SPEAKERS A,B TAPE (MONITOR} TAPE MONITOR A A SPEAKERS TAPE MONITOR ] Basic operations [ ,. For front speakers with an impedance under 8Q Press and hold [A] or {B] until “LOW IMP" lights up on the display. H even one of the speakers being used has an impedance under 8102, press and hold down either [A) or [B] for 4 seconds or more to set the impedance on the main unit to LOW. (Press and hold down once again for 4 seconds or more (o aura it off.
FM MODE 1 INPUT SELECTOR © Selected band 3 vIA TUNING AQTEZIE | The radio [ Sequence (g Use the tuning buttons to tune-in radio stations. 1 Turn {INPUT SELECTOR] to select “TUNER”. 2 Press [BAND] to select “FM” or “AM”. 3 Press [TUNING (v or the desired frequency. “QUARTZ LOCK" lights up when tuned. “STEREO" lights up when an FM stereo broadcast i received.
’ 1 The radio [ Dt (Ming by cremate €o; Specify the frequency using the numbered buttons on the remote control to directly tune (o the station. 1 Press [TUNER/BAND]. This will set the remote control fo operate the tuner, Tha selector on the receiver will change 1o "TUNER", Each time the button is pressed, the band will change as follows, Press [DIRECT TUNING/DISC ENTER]. 3 While cursor display is ashing {approx. 10 seconds) Press the numbered buttons to enter the frequency.
2 o The radio 1 [Uninteresting Presetting radio stations into the emery channels of this unit makes selecting stations simple. A total of 30 FM and AM stations can be preset.
2 fl FM MODE ‘ The radio m Manual memory presetting The desired stations can be preset into the desired channels by the user. 1 Set to the desired frequency. (= Page 16-17.) i interference or static Is keeping you from enjoying an FM broadcast, press [FM MODE] and change to monaural. You can preset the stallion in monaural just as in stereo, 2 Press [MEMORY]. To cancel the memory function, press [MEMORY] again. 3 Press [TUNING select the desired channel.
Rosa STEREO, SURROUND, 3 STEED, SFC SFC MODE Galatea RO L~ SUFFERER Disunion 3 STEED 575 0o COMMODE Reproduction modes You can take advantage of the hollowing modes with this uni. u Dolby Pro Logic SURROUND mode By reproducing the feeling of depth and movement of sound, video software or Compact discs recorded with Dolby Surround provide the listener with a feeling of presence like that ot a movie theater.
STEREO Subgroup LETTERED. S6C SALT IT Ly CENTER MODE TEST “SURBOUND®: L § 1 st “38TEREC™ L ~-C—R [ et i Preparing for Dolby Pro Logic Seitinglthelcentedmodeland] adjustingfspeakefoutputievel Adjust speaker level so the pulpit from the center and surround speakers is the same apparent level when sitting where you would normally enjoy a source. Ensure you have your speakers set up in the following way.
RQT5212 ; 5 LEVEL i ! e Output level DELAY Front speaker Front speaker (let) Surround speaker Getty) e e (eighty Surround speaker {right) L l Preparing for Dolby Pro Logic 5 e Press [LEVEL] to select the center or surround speakers. 6 Press adjust the output level to the same apparent level as the front speakers. ~: Decrease the output level, +: Increase the output level.
INPUT SELECTOR L Enjoying sound modes Ensure you have your speakers set up in the following way. © The front speakers are connected to the A terminals (™ page 12) and "SPEAKERS A" is selected. 1 Turn [INPUT SELECTOR] to select the source. 2 Turn the sound mode selector to select the desired mode. The selected reproduction mode appears on ihe display. (= Page 20 for descriptions of the modes.) 3 (only if you select SFC in the above step) Select the mode. 4 Start the source.
INPUT SELECTOR DVD 6CH INPUT | N o 21N DVD 6CH INPUT mode Use this made when playing back & channel discrete sources such as Dolby Digital and DTS. To use this mode connect a DVD player, digital surround processor or any other component that has 6 channel discrete output capabilities (W page 9). Daley Digital, DTS and other 8 channel discrete sources ere recorded with each speaker channel discrete from the other.
VOLUME Tan” VOLUME ™ nx Headphones {not included) ] Other functions (ons epee Turn [BASS] to adjust the low frequency sound. Turn [TREBLE] to adjust the high frequency sound. H ™ fungous mdse bass Turn [BALANCE] to adjust the left/right sound balance. ] o ais (e send vl IR Press [MUTING]. The message “MUTING ON NOW" runs repeatedly from right to Left across the display as long as the muting function is on. Press once again to return to the previous volume lever.
CONGRATS l The remote control This cremate control can be used to operate this unit and some other Panasonic and Technicians cassette decks, CD players. TVs, VCR and DVD players. provided they are equipped with 2 remote control sensor.
[ T crams e receiver (senile) Make sure the remote contra is in the tuner operation mode. (= Page 26.) Point the remote contra! To listen to radio broadcasts toward the receiver select the desired channel directly (Preset tuning) g TRUER Changes as follows each time the button is Ic dissect FM" or pressed. AM FM— AM (_.
RQT5212 The remote control To perish & 0 [yer Tun the CD player ON before trying to operate it by remits control. Make sure the remote control is in the CO player superstition mode. (» Page 26.) 1t may not be possible to operate some CD players with this unit. Point the remote control toward the CD player To start play O {CD changer only} To start play from the desired disc For 5 CD changer Select disc number. For MEGA CD changer s sameness O OO0 . Barbs " Select the disc number.
[ oy broads ] The procedures below are examples for when a TV and VCR are connected to the receiver as shown in this manual, This remote control transmitter is designed for use with & home theater system. If you press [TV] (or [VCR]) and succession, the TV {or VCR) and receiver will be turned on and the selector on tha receiver will change 1o TV (or VCR).
AQT5212 The remote control [ o betel video Apes The procedures blow are examples for when a TV and VCR are connected 10 the receiver as shown in this manual. LYONS | = yoL | | To watch video tapes Feint the remote control toward the TV and the receiver G O wOw Switch ON the TV and the receiver. Point the remote contort toward the VCR and ihe receiver Switch ON the VCR. The receiver will switch to VCR input.
[ Peritoneum BYD player The procedures below are examples for when a TV and DVD player are connected to the receiver as shown in this manual. Make sure the remote contort is in the DVD player operation mode, (% Page 26.) Actual operations depend on your equipment and software. watch DVDs \] Point the remote control toward the TV and the receiver ki S DYG Point the remote control toward the DVD player and receiver Point the remote control toward the TV TVf ?EO TUNERS CO_ BAND 3¢ Switch ON the Switch ON the S
RQT5a12 TAPE MONITOR 1 INPUT SELECTOR TAPE MONITOR INPUT SELECTOR ) Making a recording When vou select DVD 6CH INPUT mode, only sound from the front left and right channels is recorded. To record all & channels Set the playback mode on your DVD player or decoder 1o two channel {stereo) mode. For details, see the equipment's operating instructions. B Feeding en e Eps ek Be lore recording, prepare the taps deck. Ses the tape deck’s operating instructions tor details.
Specifications (IHF’78) B AMPLIFIER SECTION Rated minimum sine wave RMS power cutout 40 Hz-20 kHz both channels driven 0.8 % total harmonic distortion 100 W per channel (8 Q) 1 kHz continuous power output both channels driven 0.05 % total harmonic distortion 105 W per channel (8 Q) Total harmonic distortion rated power at 40 Hz~20 kHz 0.8% (80} half power at 1 kHz 0.
Aavs2i2 i | Troubleshooting guide Before requesting service for this unit, check the chart below for a possible cause of the problem you are experiencing. Some simple checks or a minor adjustment on your part may eliminate the problem and restore proper operation.
[ Problem T Probable cause(s) Suggested remedy [ Page(s) | Common Problems Unit doesn't come on. The power cord plug is not fully inserted. © Confirm the pig is fully inserted, Sound is not heard. The speaker indicators are off. @ Turn on lhe speaker indicators. 14 The tape monster function is on. o Press the tape monitor button, 15 The muting function is on. @ Press the mewling bunion on the cremate 25 control. Incomplete or incorrect connection to # Check all connections.
| Servicemen List (US) Quasar treatise Request, Dealer Locations, and all Panasonic Technicians For Product malformation, Operating Assistance, L Customer Service inquiries please contact: 1-800-211-PANS (7262), Mondny~Friday 9 am-9 pm; Saturday=Sunday 9 am=7 pm, EST. Web Site: httpiiwww.
