Safety Instructions

If applicable, batteries (battery pack or batteries
installed) must not be exposed to excessive heat
such as sunshine, fire or the like.
Ventilation and positioning
This product is intended to be used indoors in a
residential or office environment.
• Remove all packaging material before applying
power to the product.
• Place and use the product only in positions as
described in the user documentation that is
included with your product.
• Never push objects through the openings in
this product.
• Do not block or cover any ventilation openings;
never stand it on soft furnishings or carpets.
• Leave 7 to 10 cm (3 to 4 inches) around the
product to ensure that proper ventilation gets
to it.
• Do not install the product near any heat sources
such as radiators, heat registers, stoves, or other
apparatus (including amplifiers) that produce
heat.
• Do not put anything on it which might spill or
drip into it (for example, lighted candles or
containers of liquids). Do not expose it to
dripping or splashing, rain or moisture. If a liquid
enters inside the product, or if the product has
been exposed to rain or moisture, unplug it
immediately and contact your supplier or
customer service.
Wall mounting
When the equipment is designed to be wall
mount, it must be installed at a height of less than
2m from the finished floor level.
Cleaning
Unplug this product from the wall socket and
disconnect from all other devices before cleaning.
Do not use liquid cleaners or aerosol cleaners.
Use a damp cloth for cleaning.
Water and moisture
Do not use this product near water, for example
near a bathtub, washbowl, kitchen sink, laundry
tub, in a wet basement or near a swimming pool.
Transition of the product from a cold environment
to a warm one may cause condensation on some
of its internal parts. Allow it to dry by itself before
using the product.
Product label
For some products, the label with regulatory and
safety information can be found on the bottom of
the enclosure.
Electrical powering
The powering of the product must adhere to the
power specifications indicated on the marking
labels.
In case this product is powered by a power supply
unit:
• For USA and Canada: This product is intended
to be supplied by a UL listed Direct Plug-in
Power Unit marked "Class 2" and rated as
indicated on the label on your product.
• This power supply unit must be Class II and a
Limited Power Source in accordance with the
requirements of IEC 62368-1/EN 62368-1,
Annex Q and rated as indicated on the label on
your product. It must be tested and approved
to national, or local standards.
Accessibility
The plug on the power supply cord or power
supply unit serves as disconnect device. Be sure
that the mains supply socket outlet you use is
easily accessible and located as close to the
product as possible.
The power connections to the product and the
mains supply socket outlet socket must be
accessible at all times, so that you always can
disconnect the product quickly and safely from
the mains supply.
Overloading
Do not overload mains supply socket outlets and
extension power cords as this increases the risk of
fire or electric shock.
Handling batteries
This product (or its remote control) may contain
disposable batteries.
• Do not disassemble, crush, puncture, short the
external contacts, dispose of in fire, or expose to
fire, water or other liquids.
• Insert batteries correctly. There may be a risk of
!
This product is intended for indoor use
only.
!
Only use the power supply unit that is
supplied with this product, is supplied by
your service provider or local product
supplier, or a replacement power supply
unit provided by your service provider or
local product supplier.
The use of other types of power supplies
is prohibited.
If you are not sure of the type of power
supply needed, consult the user
documentation that is included with your
product or contact your service provider
or local product supplier.
!
CAUTION
There is danger of explosion if the
battery is mishandled or incorrectly
replaced.