Setup Guide

41
SETUP & USER GUIDE
Copyright © 2012 Technicolor. All rights reserved.
DMS-CTC-20120508-0000 v1.0.
To Set up Security Settings
1 Click Home Network > Interfaces > WLAN to open the Wireless Access Point page.
2 Click Configure on the upper-right corner of the screen.
3 Under the Security section, check the Broadcast Network Name to enable wireless devices to see
the SSID of your wireless network.
4 On Encryption, select an encryption method:

Disabled — No encryption.

Use WEP Encryption — To use WEP encryption.
▪ WEP Key Length — Select the key length.
▪ WEP Encryption Key — Type the desired encryption key. Users need to enter this passkey to
connect to the wireless network.

Use WPA-PSK Encryption — To use a WPA-PSK encryption for more security.
▪ WPA-PSK Preshared Key — Type the desired passkey. Users need to enter this passkey to
connect to the wireless network.
▪ WPA-PSK Version — Select the WPA-PSK version to use.
5 Click Apply at the bottom of the page to save changes.