Setup Guide

32
SETUP & USER GUIDE
Copyright © 2012 Technicolor. All rights reserved.
DMS-CTC-20120508-0000 v1.0.
7.4.3 Set Filter Rules
After you create a new security level, you can set firewall rules.
1 On the Firewall page, click Configure on the upper-right corner of the screen.
2 Click Edit. The Firewall Settings appears.
3 On the Firewall Settings table, click Add.
4 Enter the necessary parameters:

Name — Enter desired firewall rule name

Enabled — Check this box to enable this firewall rule.

Source Interface — Select the interface to apply the firewall rule.

Source Address — Select the firewall source address.

User-Defined — If the address is not listed in the Source Address box, enter a user-defined address
here.

Destination Interface — Select the destination interface.

Destination address — Select the destination address.

User-Defined — If the address is not listed in the Destination Address box, enter a user-defined
address here.

Service — Select a service.

Action — Select the action to take: Deny or Accept.
5 Click Apply to save changes. The new firewall rule appears on the Firewall Settings table.
To edit a firewall rule, click Edit.
To delete a firewall rule, click Delete.