Operation Manual

Page 8 / 83
CHAPTER 1: CONNECTIONS AND SETUP
Turning on the Wireless Voice Gateway
After installing the Wireless Voice Gateway and turn it on for the first time (and each time the modem is
reconnected to the power), it goes through several steps before it can be used. Each of these steps is
represented by a different pattern of flashing lights on the front of the modem.
If there is no lighted LEDs on the front panel, check the power adapter plug-in the power jack and
connect to CM correctly.
Note: All indicators flash once before the initialization sequence.
If both DS and US LEDs are flashing, it means the Wireless Voice Gateway is automatically updating its
system software. Please wait for the lights to stop flashing. Do not remove the power supply or reset the
Wireless Voice Gateway during this process.
Introduction
Wireless Voice Gateway Features
 Full Band Capture Front End
 Lowers Power with Advanced Power Management
 Advanced Processor architecture.
 Cable Europe Labs Euro-DOCSIS 1.0/1.1/2.0/3.0 Standard certified.
 Euro-PacketCable 1.0/1.5 Standard certified.
 Support Multiple Provisioning mode.
 Standard RJ-45 connector for 10/100/1000BaseT Ethernet with auto-negotiation and MDIX functions.
 RJ-11 Foreign Exchange Station (FXS) port for IP telephony.
 Support simultaneous voice and data communications.
 Echo Cancellation.
 Voice Active Detection (VAD).
 DTMF detection and generation.
 Comfort Noise Generation (CNG).
 Support V.90 fax and modem services.
 SNMP network management support.
 802.11a/b/g/n are supported, 20/40 MHz bandwidth.
 Support Web pages and private DHCP server for status monitoring.