Operation Manual

Page 54 / 83
6. 5 GHz\Radio
This page allows you to configure the access control of 5 GHz AP.
Fig.2-35 Wireless\5 GHz\Radio
 Enable: It may help you to Enable or Disable the 5 GHz wireless function. To enable you need to
select Enabled, to disable you need to select Disabled.
 SSID: The SSID for 5 GHz wireless function.
 802.11 Mode: There are three different modes can be selected. Mixed, Disabled and Greenfield.
 Channel: In 802.11 Band 5GHz, there are 36, 40, 44, 48 total 4 channels for all country. Choose the
one that is suitable for this device.
 Bandwidth: Select wireless channel width 20 MHz is for default value (bandwidth taken by
wireless signals of this access point.) It can be 20 MHz or 40 MHz.
 Power: This setting decides the output power of this 5 GHz device. You may use it to economize on
electricity by selecting lower percentage of power output. Control the range of the AP by adjusting
the radio output power. The power can be 100%, 75%, 50% or 25%.