Integrator's Manual

4 = Fixed

5 = NA

6 = NA

7 = NA

8 = NoChange

Base_IP – This field gives the COM24 card a starting point for defining its IP address in several

of the modes listed above.

Subnet – This field allows you to give a subnet mask of your choosing to the COM24 card.

Clear this field to use a default subnet.

Gateway – This field allows you to set a default gateway of your choosing for the COM24 card.

Clear this field to remove the gateway value.

Time-to-Live – Time to Live field in IP protocol header.

Log_IP – This field allows you to direct the COM24 card to send its log files to an external

destination automatically. This is very useful for monitoring the health of the system over an

extended period. After entering the IP address of the destination, the log files will start being

forwarded to this address after a short delay. You may then run a system-logging utility like

Kiwi on the destination computer to capture this information.

Log_Level – This field allows you to define the level of detail that will be captured in the

resulting log files. Due to the complexity of this setting, it is strongly advised that it be left blank

unless someone from support has asked to change the value.

UtilConfig – This field is for development purposes only, and should be left blank unless you

have been asked to modify the value by someone from support.

Please refer to Appendix A for more information on using these settings.

6.8.7 Reading the COM24 CAM Log Data

The information shown in Figure 41 below is one of the subsections available on the Advanced

Edit page.