Quick Setup Guide
2
3. Connect your gateway to the Broadband service
Choose your installation method
To connect your gateway to the Internet you can either:
• Directly connect your gateway to your service provider’s fiber network. In this setup
your gateway is used as Fiber gateway. Follow the instructions from “Option A:
Connect as Fiber Gateway” on page2.
• Place your gateway behind another Internet access device. In this setup your
gateway is used as local Ethernet router. Follow the instructions from “Option B:
Connect as local Ethernet router” on page2.
Option A: Connect as Fiber Gateway
1 Remove the protective cap from the SFP module readily inserted into the port.
2 Take one end of the fibre cable and remove the protective cap from the connector.
3 Insert the connector in the port.
4 Take the other end of the fibre cable, remove the protective cap from the
connector and then insert the connector in the optical termination point.