Safety Instructions

RF exposure statement
This equipment complies with FCC radiation
exposure limits set forth for an uncontrolled
environment. End users must follow the specific
operating instructions for satisfying RF exposure
compliance. To maintain compliance with FCC
RF exposure compliance requirements, please
follow operation instruction as documented in the
product documentation.
When the product is equipped with a wireless
interface, then it becomes a mobile or fixed
mounted modular transmitter and must have a
separation distance of at least 30 cm between the
antenna and the body of the user or nearby
persons. In practice, this means that the user or
nearby persons must have a distance of at least
30 cm from the product and must not lean on the
product in case it is wall-mounted.
With a separation distance of 30 cm or more, the
M(aximum) P(ermissible) E(xposure) limits are
well above the potential this wireless interface is
capable to produce.
This transmitter must not be co-located or
operating in conjunction with any other antenna
or transmitter.
Restricted frequency bands
In case this product is equipped with a wireless
transceiver operating in the 2.4 GHz band, it can
only use channels 1 to 11 (2412 to 2462 MHz) on
U.S.A. territory.
In case this product is equipped with a wireless
transceiver operating in the 5 GHz band, it meets
all the other requirements specified in Part 15E,
Section 15.407 of the FCC Rules.
The availability of some specific channels and/or
operational frequency bands are country
dependent and are firmware programmed at the
factory to match the intended destination. The
firmware setting is not accessible by the end user.
This equipment complies with Part 68 of the FCC
Rules.
The customer information required for Telephone
Terminal Equipment ("TTE") approved for
connection to the Public Switched Telephone
Network ("PSTN"), pursuant to 47 CFR
§68.218(b)(1) is available at the following internet
address: www.technicolor.com/ch_regulatory.