- Thomson DVD Player + TV Set + VCR Owner's Manual

Connections and Setup
11
EN
Manual installation
To complete the set-up of your video recorder when the automatic channel set-up has not stored
all the channels or when you wish to store a new channel.
1. Turn on your television and your DVD/VCR. Select the AV channel on your television, press
the
VCR button and then press to access the main menu.
2. Press the and buttons to select PR SET then press OK.
3. Press again and the television channel table appears.
4. Use the and buttons to select the programme number you want to tune, then press OK.
5. Press the AV key to select C (for channels received
via your roof aerial) or S (for cable network
channels).
6. Press OK, and then use the and buttons to
search for the channel of a programme or enter the
channel number using the numbered buttons.
7. The station can be fine tuned to improve picture quality. Select MFT (Manual Fine Tuning)
using the and buttons. Use the and buttons to adjust the picture.
8. Select STATION by pressing the button. You can then name your station.
9. Press OK to reveal the television channel name list.
Use the and buttons to choose a channel name
from the list. Press
OK to select it.
10. If the station name you require is not listed you can
insert one manually. Press the button.A flashing bar
appears beneath the first letter. Use the and
buttons to select letters and numbers for the new
channel name up to a maximum of 5. Press the and
buttons to pass on to the previous or next
character. Press
OK.
11. Press to confirm.
12. Press again to remove the menu.
13. The new channel is now stored into your video recorder.
If you wish to install manually other channels you should repeat the above procedure.
To sort the new channel, see “Sorting the channels” on page 10.
Note: If it is necessary for you to tune all the channels manually you may find it easier if you write the CH
numbers down for each channel as you find them.You can then select each channel from the main menu and
type the CH numbers in directly. Each channel will then be in the correct position so there is no need to sort
them later.
P
SET
R
PR CH
06 00
C40
HR3
BR3
WDR3
ZDF
ARD
N3
NDR3
SWF3
i
OK
P
SET
R
MFT
PR CH STATION
09 - - - - - -
MFT
P
SET
R
C - -
i
CHANNEL/CABLE : AV
DTH6300E_EN 28/05/04 18:48 Page 11