- Thomson DSL Router Owner Manual

4The SpeedTouch

610 SNMP

Application Note Ed. 01

ADSL and SHDSL MIBs Following two MIBs are specific per SpeedTouch

610 variant (ADSL or SHDSL vari-

ants). You should only load the appropriate one, although loading both will not harm

functionality. To retrieve maximum SNMP information it is imperative to use the MIB

provided on the CD-rom, and not the one supported (if so) by the SNMP manager.

• RFC2662 ADSL MIB (containing ADSL-LINE-MIB and ADSL-TC-MIB)

The ADSL MIB is in fact a bundle of three MIBs: the ADSL-LINE-MIB, the ADSL-

TC-MIB and additionally the PerfHist-TC-MIB. It contains management informa-

tion about the ADSL line such as Signal-to-Noise Ratio (SNR), output power and

attainable bit rate.

• HDSL2-SHDSL-LINE MIB (containing SNMP-FRAMEWORK-MIB)

The SHDSL MIB contains management information about the SHDSL line such as

Signal-to-Noise Ratio (SNR), Loop attenuation, PSD regional setting, line rate and

line status.

SpeedTouch

610

specific MIBs

Following MIBs are specifically designed for the SpeedTouch

610:

• System MIB (Enterprise specific branch MIB)

This required MIB is for adminitrational use by the other MIBs only. It provides the

object IDs (OID) from the SpeedTouch

610 specific MIBs and defines the Enter-

prise specific object identifier.

• IPSec MIB (Product specific)

The SpeedTouch

610 specific IPSec MIB contains management information

about the IPSec protocols (in case IP VPN IPSec functionality has been enabled via

the appropriate SpeedTouch

610 software key). Details are given of Security

associations, tunnel statistics and errors.