User's Manual

2 Setup
DMS-CTC-20110909-0007 v0.118
DRAFT
2.3.2 Wired Connection to the HSG
Requirements
 Both your network device (for example, a computer, an Ethernet switch,...) and
HSG must have a free Ethernet port.
 Your network device must be configured to obtain an IP address automatically.
This is the default setting. For more information, see “10.4 Configuring Dynamic IP
Addressing on Windows” on page 95.
Procedure
Computer
HSG
Yellow Ethernet Cable
Proceed as follows:
1 Take the yellow Ethernet cable that was included in your box.
2 Plug the Ethernet cable into one of the four yellow Ethernet ports on the back of
the HSG.
3 Plug the other end of the yellow Ethernet cable into an Ethernet port on the
computer.
4 If you did not yet start up your computer, start up your computer.
5 The Ethernet LED on the front panel of your HSG should light up (solid or
blinking).
6 Use the same procedure to connect your other Ethernet devices (computers,
network printers,...).