User's Manual

2 Setup
DMS-CTC-20110909-0007 v0.110
DRAFT
Overview
To setup your HSG, you have to complete the following steps:
1 If a different router was being used previously, disconnect it. Remove all
components, including power supplies and cables; they will not work with the
HSG.
2 Connect the HSG to the Cantenna.
For more information, see “2.1 Connect the HSG to the Cantenna” on page 11.
3 Power on your HSG.
For more information, see “2.2 Power on the HSG” on page 12.
4 Connect your network devices.
For more information, see “2.3 Connect Your Network Devices” on page 13.
5 Optionally, you can further configure the HSG to your needs (for example, change
the wireless security) using the Graphical User Interface (GUI) of the HSG.
For more information, see
In case of problems
If you have trouble configuring your HSG, try the following:
1 Refer to “Support” on page 87.
2 If you did not find a solution in the Troubleshooting section, call the Help Desk at
800- 837-4966.