User's Manual

 Must not be mounted in a location exposed to direct or excessive solar

and/or heat radiation.

 Must not be exposed to heat trap conditions and must not be subjected to

water or condensation.

 Must be installed in a Pollution Degree 2 environment (Environment

where there is no pollution or only dry, nonconductive pollution).

Cleaning

Unplug this product from the wall socket and computer before cleaning. Do

not use liquid cleaners or aerosol cleaners. Use a damp cloth for cleaning.

Water and moisture

Do not use this product near water, for example, near a bathtub, washbowl,

kitchen sink, laundry tub, in a wet basement or near a swimming pool.

Transition of the product from a cold environment to a hot one, may cause

condensation on some of its internal parts. Allow it to dry by itself before re-

starting the product.

Interface classifications

The external interfaces on the rear panel of the product are classified as

follows:

 Phone, VoIP, FXS: TNV circuit, not subjected to overvoltages (TNV-2)

 All interface ports (e.g. Coax, Ethernet, 10/100Base-T/MDI(-X), USB,

etc.), including the low voltage power input from the AC mains power

supply: SELV circuits.

Electrical powering

The powering of the product must adhere to the power specifications

indicated on the marking labels.

The power supply must be Class II and a Limited Power Source in

accordance with the requirements of IEC60950-1/ EN60950-1, Clause 2.5

and rated as indicated on the label on your product. It must be tested and

approved to national or local standards.

For US and Canada: This product is intended to be supplied by a Listed

Direct Plug-in, or Desktop Power Unit marked "Class 2" and rated as

indicated on the label on your product.

WARNING

It is not allowed to connect the Coax port to a cable distribution or

cable television network by any means, e.g. with a coaxial cable.

FOR APPROVAL