TG788v v3 for Claro Puerto Rico Quick Installation Guide xDSL IAD wireless gateway
1. Before you start Carefully read the Safety Instructions and Regulatory Notices document included in your package before continuing with the installation of your TG788v v3. 2.
. Attach the vertical stand Place the locking catches of the vertical stand into the slots on your TG788v v3 and slide the mountable stand into place. 4. Connect your TG788v v3 to the Broadband service DSL LINE ADSL PHONE 1 Plug the DSL cable into the grey port labelled DSL of your TG788v v3. 2 Plug the other end of the DSL cable into the DSL/Modem port of one of the DSL filters. Plug the cable of the DSL filter into your telephone wall socket.
5. Power on your TG788v v3 1 Plug the connector of the electric power supply adapter into your TG788v v3 power inlet port. Plug the adapter into a nearby power outlet. 2 Press the power button ( ) on the back panel. After a few minutes, the Power LED on the front panel must be solid green. If this is not the case, check the connections that you made in the previous steps. If the Power LED is blinking green or orange, your TG788v v3 is updating its software.
7. Connect your wired (Ethernet) devices If you want to connect a device using a wired (Ethernet) connection: 1 Take the Ethernet cable with the yellow connectors. 2 Connect one end of the Ethernet cable to one of the yellow Ethernet ports on your TG788v v3. 3 Connect the other end of the Ethernet cable to your device. 4 Connect your other Ethernet devices. 5 We recommend you to first configure your TG788v v3 (see “9.
You can now connect your wireless device: • Automatically using WPS: 1 Start WPS Push Button Configuration (PBC) on your wireless device. 2 If your wireless device prompts you to select your access point from a list, select the item that uses the Network Name printed on the back label of your TG788v v3. 3 Briefly press the WPS button on the front panel of your TG788v v3. WPS 4 The WPS LED on the front panel starts blinking orange.
3 The TG788v v3 may offer you to change your password. Select one of the options and then click Save. If you chose to change the password, type your current password in the first box, type your new password twice and then click Change Password. Your new password must contain at least 12 characters including both upper and lower case letters, at least one number and at least one special character. Step 2: Check your Internet connection Under Internet Access, check the status of your Internet connection.
*DSL37695800* DSL37695800 TECHNICOLOR 1-5 rue Jeanne d’Arc 92130 Issy-les-Moulineaux France www.technicolor.com Copyright 2017 Technicolor. All rights reserved. All tradenames referenced are service marks, trademarks, or registered trademarks of their respective companies. Specifications subject to change without notice. DMS3-QIG-25-433 v1.0.
