User's Manual
Table Of Contents
- About this Setup and User Guide
- 1 Installation
- 2 Thomson Gateway Basics
- 3 Adding a New Computer to your Network
- 4 Wireless
- 5 Telephony
- 6 Getting the Most Out of Your Thomson Gateway
- In this chapter
- Feature availability
- 6.0.1 Using UPnP AV to Share Content with Media Devices
- 6.1 Universal Plug and Play
- 6.2 Assigning a service (HTTP, FTP,...) to a computer
- 6.3 Dynamic DNS
- 7 Internet Security
- 8 Troubleshooting
- Introduction
- Topics
- 8.1 Setup wizard Troubleshooting
- 8.2 General Thomson Gateway Troubleshooting
- 8.3 Voice over IP Troubleshooting
- 8.4 Reset to Factory Defaults
E-DOC-CTC-20080421-0002 v1.0
38
5 Telephony
Activate Waiting when you want to:
To retrieve the call on hold (when there is
no active call)
R, 1
To terminate an active call and enables a
call set up (the dial tone is generated)
R, 9
Action Press Illustration
To terminate an active call and switch to an
incoming call
R, 1
To reject an incoming call R, 0
To switch between an active call and a call
on hold
R, 2
To switch between an active call and an
incoming call
R, 2
Action Press Illustration
CB
A
active
CB
A
on hold
A presses
R1
CB
A
dial tone
on hold
CB
A
active
on hold
A presses
R9
CB
A
active
CB
A
active
incoming
A presses
R1
CB
A
active
CB
A
active
incoming
A presses
R0
CB
A
on hold
active
CB
A
active
on hold
A presses
R2
CB
A
on hold
active
CB
A
active
incoming
A presses
R2