User Manual
Table Of Contents
- About this Installation and Setup Guide
- 1 Introducing the Thomson Gateway
- 2 Basic Installation
- Before you begin
- ADSL service
- Computer requirements
- Wireless client adapters
- Internet connection details
- 2.1 Mounting your Thomson Gateway
- 2.2 Installing your Thomson Gateway
- 2.3 The Setup CD
- 2.4 Thomson Gateway Connection Essentials
- 2.5 Connections Overview and Powering
- 2.6 Basic Security
- 3 Web-Based User Interface
- 4 Troubleshooting
E-DOC-CTC-20060911-0041- v1.0
Chapter 4
Troubleshooting
41
4.7 Reset to Factory Defaults
Resetting your Thomson Gateway
You might consider a reset to factory defaults as described below.
A reset to factory default settings deletes the configuration profile settings. Therefore, after the reset, a
reconfiguration of your Thomson Gateway will be needed.
Reset to default configuration
Proceed as follows:
1 Make sure the Thomson Gateway is turned on.
2 Use a pen or an unfolded paperclip to push the recessed reset button on the back panel. The reset button
is marked with a red circle. Push it until the power LED lights red - this will take about 7 seconds.
3 Release the reset button.
4 The Thomson Gateway restarts.
!
Be aware that a reset to factory defaults will revoke all configurational changes you made to the
Thomson Gateway.
Ethernet
1432
DSLReset
1
2
4
3
ON/OFF