User Manual
Table Of Contents
- About this Installation and Setup Guide
- 1 Introducing the Thomson Gateway
- 2 Basic Installation
- Before you begin
- ADSL service
- Computer requirements
- Wireless client adapters
- Internet connection details
- 2.1 Mounting your Thomson Gateway
- 2.2 Installing your Thomson Gateway
- 2.3 The Setup CD
- 2.4 Thomson Gateway Connection Essentials
- 2.5 Connections Overview and Powering
- 2.6 Basic Security
- 3 Web-Based User Interface
- 4 Troubleshooting
E-DOC-CTC-20060911-0041- v1.0
Chapter 4
Troubleshooting
39
How to Establish a Wireless Connection using the WZC
Proceed as follows to start and use the WZC service:
1 Open the Wireless Network Connection window (see above)
2 From the list, double-click the network you wish to connect to, or select it and click Connect.
Result: The WZC may prompt you for an SSID and a WPA or WEP Key (in case of a secure network):
3 If applicable, fill in the SSID and the key and click Connect.
Result: a wireless connection to your Thomson Gateway will be established. When the connection is
ready, Windows informs you through a popup balloon in the notification area:
i
The typical SSID is SpeedtouchXXXXXX where XXXXXXrepresents a set of alphanumerical
characters. You can find the SSID and the key on the label on the bottom of the Thomson
Gateway.
i
For more detailed information about starting and using the WZC service, visit the Microsoft
knowledge base on http://support.microsoft.com.