User Manual
Table Of Contents
- About this Installation and Setup Guide
- 1 Introducing the Thomson Gateway
- 2 Basic Installation
- Before you begin
- ADSL service
- Computer requirements
- Wireless client adapters
- Internet connection details
- 2.1 Mounting your Thomson Gateway
- 2.2 Installing your Thomson Gateway
- 2.3 The Setup CD
- 2.4 Thomson Gateway Connection Essentials
- 2.5 Connections Overview and Powering
- 2.6 Basic Security
- 3 Web-Based User Interface
- 4 Troubleshooting
E-DOC-CTC-20060911-0041- v1.0
Chapter 2
Basic Installation
11
3 Make one of the following connections:
Connect the yellow RJ-45 Ethernet cable to the yellow (indicated) Ethernet port on your Thomson
Gateway and the other end to the computer’s Ethernet port.
For wireless networking, plug a wireless card or adapter into your computer.
4 Once the hardware is installed and connected to the Thomson Gateway, the procedure continues with
configuring your Internet connection.
Proceed with “ Configuring the Internet connection” on page 12.
i
In case of problems or for advanced information, see “2.5.1 Wireless Setup” on page 22.
i
If the wizard does not detect a connection, an error message will be displayed. Refer to “The
wizard does not detect a connection” on page 35.