User's Manual
Table Of Contents
- About this Setup and User Guide
- 1 Introduction
- 2 Installation
- 3 The THOMSON TG185n as Wireless Access Point
- Usage
- In this chapter
- 3.1 Configuring The THOMSON TG185n As Access Point
- Procedure
- Switch the THOMSON TG185n to access point mode
- Assign a static IP address to your computer
- Configure the wireless settings of your THOMSON TG185n
- Configure the IP settings of your THOMSON TG185n (optional)
- Connect your THOMSON TG185n to your Internet gateway
- Configure your wireless clients
- Configure your computer to obtain an IP address automatically
- 3.2 Connecting a Wireless Client via WPS
- 3.3 Manually Configuring a Wireless Client
- 3.4 Securing Your Wireless Network
- 4 The THOMSON TG185n as Wireless Repeater
- 5 Your THOMSON TG185n as Wireless Client
- 6 THOMSON TG185n Basics
- 7 Support
- Introduction
- Topics
- 7.1 Assigning a Static IP to Your Computer
- 7.2 Restoring the IP Settings of Your Computer
- 7.3 General THOMSON TG185n Troubleshooting
- 7.4 Reset to Factory Defaults
E-DOC-CTC-20080624-0009 v0.2
13
3 The THOMSON TG185n as Wireless Access Point
3.2.2 PIN Code Entry On The Wireless Client
Get the THOMSON TG185n’s PIN code
You can find the WIRELESS PIN:
On the label on the bottom of your THOMSON TG185n.
On the THOMSON TG185n Web Interface:
1 Open your web browser and browse to http://192.168.1.11
.
2 On the Basic Setting menu, click Wireless Setting.
3 You can find the PIN code in the WPS Pin box.
Enter the THOMSON TG185n’s PIN code in the client utility
Proceed as follows:
1 Open the configuration utility of your wireless client.
2 Start WPS on your wireless client and choose to enter a PIN from your access point. For example, on the
TG121n Wireless Client Utility you will see the following screen:
3 Enter the PIN code of your THOMSON TG185n and follow the instructions. For example, on the TG121n
Wireless Client Utility you will see the following screen:
4 At the end of the installation your utility will inform you that WPS was successful.