User Manual
Table Of Contents
- About this Setup and User Guide
- 1 About your Wireless USB Adaptor
- 2 Install the Drivers
- 3 Associate your Wireless USB Adaptor to your Access Point
- 4 Wireless Configuration Utility
- 5 Troubleshooting
E-DOC-CTC-20080318-0006 v1.0
11
Chapter 3
3.2 Manual Association
What operating system are you using?
If your computer runs:
Windows Vista, proceed with “3.2.1 Association on Windows Vista” on page 12.
Windows XP, proceed with “3.2.2 Association on Windows XP” on page 13.
Windows 2000, proceed with “3.2.3 Association on Other Windows Operating Systems” on page 14.
If you are using the Access Control List (ACL)
Some access points enable you to allow/deny wireless clients to access your network based on their MAC
address. If you configured this feature on your access point, you must add the MAC address of the
THOMSON TG121n to the ACL.
You can find this MAC address on the back of your Wireless USB Adaptor.
In case of problems
If you encounter problems during the installation, consult “5 Troubleshooting” on page 25.