User Manual
Table Of Contents
- About this Setup and User Guide
- 1 About your Wireless USB Adaptor
- 2 Install the Drivers
- 3 Associate your Wireless USB Adaptor to your Access Point
- 4 Wireless Configuration Utility
- 5 Troubleshooting
E-DOC-CTC-20080318-0006 v1.0
10
Chapter 3
3.1.2 Procedure for All Access Points
Procedure
Proceed as follows:
1 Double-click the Wireless Configuration Utility icon in the notification area.
2 The Wireless Configuration Utility appears.
3 Click WPS.
4 The WiFi Protected Setup wizard appears:
Following options are available:
Push the button on my access point.
If you select this option, you will have to push a button on your access point to start the WPS
registration.
Enter a PIN into my access point.
If you select this option the Wireless Configuration Utility will generate a PIN code that you will have
to enter on the interface of your access point.
Enter the PIN from my access point.
If you select this option, you will have to enter a PIN code provided by your access point. If you are
using a Thomson access point, you can find this PIN code on a label on your Thomson access point.
5 Select the option of your choice and click Next.
6 Follow the instructions.