User's Manual

10 TouchScreen Quick Start Guide
l Interior motion detectors are not armed.
l Entry/Exit zones start an Entry Delay.
l Exit Delay starts when the system is armed.
l Exit Delay does not beep and is twice the length of Alarm Away mode.
Arm Night Mode
The Arm Night mode, is used when everyone is going to bed.
This mode works the same as Arm Stay except that there is no Entry Delay period. If an entry/exit zone
is opened, an alarm sounds immediately.
Note: There is still an Exit Delay period that works the same as in Arm Stay mode.
Arming and Disarming the System
The Security status of your security system is displayed in the Security Status header.
The message that the Security Status header displays
when the status is “Disarmed”.
Tap to arm the system.
The message that the Security Status header displays
when the status is “Armed”.
Tap to disarm the system.
Arming the System from the TouchScreen
To arm the system from the TouchScreen:
1. Tap the Security Status header when it is in Disarmed state.
The Security Options screen is displayed with a keypad and the Arm System tab open.